Insinger Admiral 44-4 User Manual download pdf (Page 22)

Motor Overloads

All motors used on Insinger Machines are provided

with motor overloads. Motor overloads are adjusted

when the machines are factory tested. Should it be

necessary to adjust the motor overloads in the field

first verify the motor current draw for the voltage

the machine is using.

Using the Control Panel Component Layout Dwg.

located in Section 3 to identify the overload adjust

by turning the dial to the appropriate AMP draw.

Final Rinse Actuator

The final rinse is actuated by a level located on the

rear wall of the dishwasher near the exit end. When

a rack depresses it a switch is closed and a sole-

noid energized.

The activation of the lever also resets the Energy

Saver Timer (P/N DE7-28). The timer will then start

counting from 0. The timer is adjustable between 0

and 300 seconds (5 minutes). See dwg. 116-145.

NOTE:

The overfill timer MUST be adjusted during

initial start-up. Adjustment depends on water

fill pressure. The water level MUST be 1/4”

below the lip of the overflow tube. Adjust by

increasing or decreasing the potentiometer on

the level timer.

NOTE:

Dirty level floats will cause the tank heat to

energize with no water in the tanks.

LEVEL FLOATS MUST BE CLEANED DAILY.

PART 5 MAINTENANCE & REPAIR PROCEDURES

Level System

The level control system consists of one overfill

timer (P/N DE7-35) and one level float (P/N DEF-

60) per tank.

When the system is powered-up, the tank(s) will

begin to fill (assuming no water is in the tanks).

When the level float is actuated, the overfill timer

begins to time-out and continues the filling process

until the tank(s) is full.

Liquid Level Timer DE7-35

Sk-4698

Admiral Series DOC ADM-ES 1.0 04

www.insingermachine.com 800-344-480220

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 64 65

Comments to this Manuals

No comments

Insinger Admiral 44-4 User Manual Page 22

Comments to this Manuals

Related products and manuals for Radiators Insinger Admiral 44-4